assistants:ignore_ac_input_using_the_generator_assistant
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
assistants:ignore_ac_input_using_the_generator_assistant [2014-07-26 00:33] – [Introduction] mvader | assistants:ignore_ac_input_using_the_generator_assistant [2019-01-22 10:16] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 5: | Line 5: | ||
Ignoring AC input will force a Multi or Quattro into inverter-mode on certain conditions, even though there is mains or generator power available. For example to force the system to run 100% on battery and solar power. | Ignoring AC input will force a Multi or Quattro into inverter-mode on certain conditions, even though there is mains or generator power available. For example to force the system to run 100% on battery and solar power. | ||
- | Ignoring the AC input was first introduced on the Virtual switch tab and can also be made with Assistants. | + | Ignoring the AC input was first introduced on the Virtual switch tab. It is much easier to use the Virtual switch to configure this, however if you must disable the Virtual switch due to another necessary assistants then it is possible to use an alternative way. |
- | + | ==== Other solutions | |
- | ==== Other options | + | Instead |
- | Note that in many cases there are better options than implementing this combination | + | - Use the Virtual switch |
+ | - For systems with recent hardware, which has the new-type microprocessor (the 7 digit firmware numbers starts with 26 or 27, instead of 19 or 20) you could use the the [[https:// | ||
==== Making AC Ignore by using the Generator start/stop and the General flag assistant ==== | ==== Making AC Ignore by using the Generator start/stop and the General flag assistant ==== | ||
The most common (or only?!) system where below assistant configuration makes sense is an AC-coupled PV installation, | The most common (or only?!) system where below assistant configuration makes sense is an AC-coupled PV installation, | ||
Line 23: | Line 23: | ||
{{ : | {{ : | ||
+ | |||
+ | |||
+ | |||
+ | ===== DISQUS ===== | ||
+ | ~~DISQUS~~ | ||
assistants/ignore_ac_input_using_the_generator_assistant.1406327595.txt.gz · Last modified: 2014-07-26 00:33 by mvader