Skip to main content

Blue Smart IP65 Charger

Re-enabling Bluetooth

Bluetooth communication can be re-enabled using the MODE button on the charger.

To re-enable Bluetooth:

  1. Connect the Blue Smart IP65 Charger AC power cable to a mains power outlet; after a short delay the TEST LED will begin to blink, until the charger determines if the battery will successfully accept charge (for up to 2 minutes).

    Image_-_LED_Charge_State_and_Mode_-_BSC_IP65.png

  2. Depress and hold down the MODE button on the Blue Smart IP65 Charger for 10 seconds.

    Image_-_Mode_button_-_BSC_IP65.png

  3. After 10 seconds have elapsed all charge mode LEDs will blink twice to indicate that Bluetooth operation has been successfully enabled.

    Image_-_LED_Charge_Mode_-_BSC_IP65.png

  4. Bluetooth operation has now been re-enabled.

Notice

During this procedure:

  1. Bluetooth operation is re-enabled

  2. The Bluetooth PIN code is reset to 000000 (not the default PIN code stated on the label)

  3. Bluetooth pairing information is cleared

Accordingly it is necessary to unpair all devices (mobile phones or tablets) previously paired with the Blue Smart IP65 Charger and establish a new Bluetooth pairing.