Skip to main content

Blue Smart IP65 Charger

Reset to defaults

If required, all Blue Smart IP65 Charger settings can be reset/restored to factory defaults using a Bluetooth enabled device (mobile phone or tablet) with the VictronConnect app.

Note this operation does not reset any Bluetooth related settings, such as the Bluetooth PIN code or pairing information.

To reset all settings to factory defaults:

  1. Connect the Blue Smart IP65 Charger AC power cable to a mains power outlet; after a short delay the TEST LED will begin to blink, until the charger determines if the battery will successfully accept charge (for up to 2 minutes).

    Image_-_LED_Charge_State_and_Mode_-_BSC_IP65.png

  2. Using a Bluetooth enabled device (mobile phone or tablet), open the VictronConnect app and locate the Blue Smart IP65 Charger in the Device list Local page, then connect to the device (the default PIN code is stated on a label located on the back of the charger, or try 000000 if there is no label).

    VictronConnect_-_Device_list__My_devices__-_BSC_IP65.jpg

  3. Select the Settings icon (gear in the top right corner) to access the Settings page.

    VictronConnect_-_Settings_-_BSC_IP65.jpg

  4. Select the Device options icon (three vertical dots in the top right corner) to access the Device options dropdown menu.

    VictronConnect_-_Settings__Options_.jpg

  5. Select Reset to defaults from the dropdown menu to open the Restore device pop-up dialog box.

    VictronConnect_-_Device_options__Reset_to_defaults__-_BSC_IP65.jpg

  6. Read the warning message, then select Yes to proceed.

    VictronConnect_-_Restore_device.jpg

  7. All settings have now been reset/restored to factory defaults.