Skip to main content

Blue Smart IP22 Charger

Resetting the PIN code

If the PIN code is forgotten or lost, it can be reset to the default 000000 using the MODE button on the charger or a Bluetooth enabled device (such as a mobile phone or tablet) with the VictronConnect app.

Reset PIN using the charger

To reset the Bluetooth PIN code:

  1. Connect the AC power cable to a mains power outlet; after a short delay, the LEDs indicating the current charge mode and charge state will illuminate.

  2. Depress and hold the MODE button on the Blue Smart IP22 Charger for 10 seconds.

  3. All charge mode LEDs will blink twice to indicate that the PIN code has been successfully reset.

    Image_-_LED_Charge_Mode_-_BSC_IP22.png

Notice

During this procedure:

  1. The PIN code is reset to default (000000)

  2. The active Bluetooth connection is disconnected

  3. All Bluetooth pairing information is cleared

Accordingly, it’s also necessary to remove/clear the Blue Smart IP22 Charger Bluetooth pairing information from any Bluetooth enabled devices (mobile phones or tablets) that were previously paired before attempting to re-connect.

Reset PIN using Bluetooth

To reset the Bluetooth PIN code:

  1. Locate and record the PUK code for reference later; the PUK code is located on a label stuck to the back of the Blue Smart IP22 Charger.

  2. Connect the AC power cable to a mains power outlet; after a short delay, the LEDs indicating the current charge mode and charge state will illuminate.

  3. Using a Bluetooth enabled device (such as a mobile phone or tablet), open the VictronConnect app and locate the Blue Smart IP22 Charger in the 'LOCAL' page device list.

  4. Select the ‘device options’ icon (three vertical dots on the right side of the description) to access the Bluetooth pairing ‘device options’ menu.

    VictronConnect_-_Device_list__Other__-_BSC_IP22.jpg
  5. Select 'Reset PIN code' to open the ‘Reset PIN code’ window.

    VictronConnect_-_Reset_PIN_code_-_BSC_IP22.jpg
  6. Enter the PUK code (recorded earlier) and select ‘OK’.

    VictronConnect_-_Reset_PIN_code_menu_-_BSC_IP22.jpg
  7. All charge mode LEDs will blink twice to indicate that the PIN code has been successfully reset.

    Image_-_LED_Charge_Mode_-_BSC_IP22.png

Notice

During this procedure:

  1. The PIN code is reset to default (000000)

  2. Bluetooth pairing information is not cleared

Accordingly, it's not necessary to remove/clear the Blue Smart IP22 Charger Bluetooth pairing information from any Bluetooth enabled devices (mobile phones or tablets) that were previously paired before attempting to re-connect.